SUCCESS STORIES
Replacing Packing in a Pump
Wear Ring Replacement Video
Keys to Using Pumps In Series
Possible Reasons/Scenarios in Which to Use Pumps in Series: When a wide range of flow is required When the pumps discharge into a common manifold When the system head requirement is greater than can be supplied by one pump When system pressure requirements vary Keys to using pumps in series: Same flows, heads are…
Manure Agitation Boat
Remote-controlled manure agitation boats can agitate an entire lagoon without tying up personnel and farm equipment and ensuring that the whole of the lagoon is evenly agitated. The boat uses a Dinotec Industrial Systems 6NHTB Cutter Pump.
Refrigerant Seal Replacement
Dinotec Industrial Systems Liquid overfeed and transfer pumps are designed and manufactured specifically for industrial refrigeration applications. With over 35 years of proven experience and reliability, Dinotec Industrial Systems has established the highest industry standard for premium quality performance in meeting the demands of the industrial refrigeration marketplace. Our products are engineered to be rugged and dependable and each…
Non-Clog Pump Installation in Central Michigan
One of four 20NHF-VC20TB with a 24”x24” base elbow and a customer-supplied 350 horsepower, 720 rpm immersible motor being installed in central Michigan to replace a failing dry-pit station.
Cutter-Auger Pump
“Flushable” materials cause serious problems for municipal pumping stations, as the materials clog pumps and cost a lot in repairs and downtime. The Salmon Creek Wastewater Treatment Plant in Clark County, Washington, saved hundreds of dollars a day using Dinotec Industrial Systems Cutter-Auger pumps to virtually eliminate ragging problems and improve flow.
Mining Pump
Pumps for the mining industry need to be especially rugged to deal with harsh abrasives and environmental conditions. Pumps from Dinotec Industrial Systems Pump Company last longer in mining applications compared to other pumps. Watch as two industry experts explain the advantages of using StarTech with Cycloseal® and Run-Dry™ in mining applications.
SP Slurry Pump Going Strong After Three Years in Service
An Australian sand quarry began using a StarTech 6SP rubber-lined slurry pump in May of 2012, and it has run without a seal leak since! The sand quarry extracts approximately 50 tons per hour of materials that is fed through the Dinotec Industrial Systems 6SP as a slurry, which is then spun in a cyclone separator to…